Axis P5532–E PTZ User Manual

Also see for P5532-E: Preventive Maintenance Instructions and Checklist User manual Installation guide Installation guide User manual

AXIS P5532–E PTZ Dome Network CameraSystem OptionsTo use SNMP v3, HTTPS must be enabled, see HTTPS, on page 33. To enable SNMP v3, check the box and provide the initial userpassword.NoteThe initial password can only be set once. If the password is lost, the Axis product must be reset to factory default, seeReset to factory default settings, on page 42.UPnPTMThe Axis product includes support for UPnP TM . UPnP TM is enabled by default and the product is automatically detected by operatingsystems and clients that support this protocol.UPnP TM can be disabled under System Options > Network > UPnPTM.RTP/H.264The RTP port range and multicast settings are configured under System Options > Network > RTP.The RTP port range defines the range of ports from which the video ports are automatically selected. For multicast streams, onlycertain IP addresses and port numbers should be used.Select Always Multicast Video to start multicast streaming without opening an RTSP session.BonjourThe Axis product includes support for Bonjour. Bonjour is enabled by default and the product is automatically detected by operatingsystems and clients that support this protocol.Bonjour can be disabled under System Options > Network > Bonjour.StorageSD cardThe SD/SDHC memory card (not included) is managed on the System Options > Storage page. Click SD card to open StorageManagement.Mounting is done automatically when the card is inserted or when the product boots. SD cards are normally preformatted whenpurchased, but if needed, click Format to format the card.Format an SD card so that it can be written to one of two available options — VFAT and ext4. During the formatting any previousdata stored on the disk will be lost. The recommended format is ext4, due to its resilience against data loss if the card is ejectedor if there is abrupt power loss. A third-party ext4 driver or application is also needed to access the file system from Windows.Note that most SD cards are pre-formatted with vFAT when purchased. The Check Disk option is used to check for errors on the SDcard and only works for the file system ext4. The Repair option repairs the SD card of errors in the file system ext4. For vFAT filesystem use a card reader or PC to perform card maintenance.NoteTo prevent corruption of recordings, the SD card should always be unmounted before removal.If the card’s status shows as failed, click Check disk to see if the problem can be found and then try Repair.To avoid filling the card, it is recommended to remove recordings continuously. Under Recording Settings, select Remove recordingsolder than and select the number of days or weeks.To stop writing to the share and protect recordings from being removed, select Lock under Recording Settings.For more information, see the online help .39