Axis Q1615-E Mk II Installation Manual

Also see for Q1615-E Mk II: User manual User manual

AXIS Q1615-E Mk II Network Camera• Using any other than the provided cable gland may cause water to seep in and damagethe product.• Always use a shielded network cable (STP) intended for outdoor use between theAxis product and the end point and ensure that the end point is properly grounded.Installations of Axis products using a shielded network cable (STP) and a properlygrounded end point have been tested to comply with industry immunity standard levelssuch as surge protection. Any other installation method will void the warranty andleave the unit at a risk.• An optional cable with a diameter of 4.0 mm - 5.5 mm should be routed through aseparate cable gland. See Product overview on page 10.1. Use the supplied drill template to prepare a wall or pole for installation of the wallbracket.2. Route the network cable through the wall bracket, and through the bracket adapter.Leave approximately 30 cm (11.8”) of cable for connecting to the camera.3. Install the wall bracket on a wall, ceiling, or pole using screws and plugs appropriate forthe material (e.g. wood, metal, sheet rock, stone).Do the following to route the network and other (optional) cables:1. Loosen the bottom cover screws and lift the top cover.2. Loosen the cable cover screws; detach the cable cover from the bottom cover.3. Remove the cap, the plug and the gasket from the cable gland to be used.4. Remove the grounding screw, washer and grounding shoe ring.5. Fasten the shoe ring mounted grounding wire and washer with the grounding screw.20