Axis S P13-E Installation Manual

Also see for AXIS P1353-E: User manual Installation guide User manual

AXIS P13-E Network Camera Series6. Turn the lens slowly clockwise until the status indicator flashes green or amber (not red).7. Retighten the focus puller.8. Open the Live View page in the web browser and check the quality of the image.9. On the Focus page, click Fine-tune focus automatically and wait until automatic finetuning is completed.10. Click Enable iris. If the button is inactive the iris is already enabled.11. If needed, make further adjustments under the Advanced tab. See the online help formore information.Reset to Factory Default SettingsImportantReset to factory default should be used with caution. A reset to factory default will resetall settings, including the IP address, to the factory default values.NoteThe installation and management software tools are available on the CD supplied with theproduct and from the support pages on www.axis.com/techsupTo reset the product to the factory default settings:1. Disconnect power from the product.2. Press and hold the control button and reconnect power. See Hardware Overview onpage 10.3. Keep the control button pressed for about 15–30 seconds until the status LED indicatorflashes amber.4. Release the control button. The process is complete when the status LED indicator turnsgreen. The product has been reset to the factory default settings. If no DHCP server isavailable on the network, the default IP address is 192.168.0.905. Using the installation and management software tools, assign an IP address, set thepassword, and access the video stream.6. Refocus the product.It is also possible to reset parameters to factory default via the web interface. Go to Setup> System Options > Maintenance.Further InformationThe User Manual is available at www.axis.comVisit www.axis.com/techsup to check if there is updated firmware available for your networkproduct. To see the currently installed firmware version, go to Setup > About.21ENGLISH