Axis T8341 User Manual

Also see for T8341: Installation guide User manual Installation guide

Contents

AXIS T8341 PIR Motion SensorHow to add a device to a Z-Wave NetworkHow to add a device to a Z-Wave NetworkAuto-inclusionThe motion sensor supports the auto-inclusion feature, where it will automatically enter Inclusion mode when first powered up.This will also apply when powered up after a factory reset.1. Use a screwdriver to detach the battery cover.2. Put the AXIS M5065 camera (or other Z-Wave controller) into inclusion mode.3. Insert 1 CR123 3V batteries into the battery compartment, observing the correct polarity. The LED on the device shouldturn ON.4. Enter the PIN number into the Z-Wave controller. See the installation guide for where to find the PIN number on the device.5. The inclusion process should be complete when the LED stops blinking.6. Perform a test before you refit the battery cover. See How to test the Z-Wave Device.Manual inclusionYou can also choose to manually add the Z-Wave device to a control device. Follow the steps below.NoteFor best results, exclude the device before starting the inclusion process. For more details see the installation guide.1. Use a screwdriver to detach the battery cover.2. Put the AXIS M5065 camera (or other Z-Wave controller) into inclusion mode.3. Insert 1 CR123 3V batteries into the battery compartment, observing the correct polarity. The LED on the device shouldturn ON.4. Press the tamper switch 3 times within 1.5 seconds to put the unit into learning (inclusion/exclusion) mode.5. Enter the PIN number into the Z-Wave controller. See the installation guide for where to find the PIN number on the device.6. The inclusion process should be complete when the LED stops blinking.7. Perform a test before you refit the battery cover. See How to test the Z-Wave Device.Manual exclusion1. Use a screwdriver to detach the battery cover.2. Press the tamper switch 3 times within 1.5 seconds to put the unit into learning (inclusion/exclusion) mode.3. The exclusion process should be complete when the LED stops blinking.4. Refit the battery cover.5