Basic InstallationAXIS OfficeBasic USB User’s Manual 13Section 3 Basic InstallationConnecting the Hardware1. Make sure that your printer is switched off and that the print server’sPower Adapter is disconnected.2. Locate the serial number, found on the underside label of the print server,and write it down. You will need this number to configure the print server.Example: S/N: 00408c181cf03. Connect the printer to the USB port using the USB cable.4. Connect the print server to the network using a twisted pair category 5cable, 10baseT or 100baseTX.5. Switch on the printer and make sure it is ready for use.6. Connect the Power Adapter to the print server. The power indicator will lightup. When the network indicator starts to flash, the print server is correctlyconnected to the network.7. Wait 1 minute. Press the test button on the print server once to print a testpage. The test page includes a list of the most important parameters.Power AdapterconnectorEthernetconnectorNetworkindicatorPowerindicatorUSB printer port (USB1)Test button
