B9Creations B9Clean User Manual
Also see for B9Clean: Quick start guide
                         | |
Contents
| 
7.3 Positioning the inner container drain plug.The back of the inner container has two drain holes. TheB9Clean’s drain plug shall be snugly inserted into one of the twoholes before starting the cleaning cycle.If the height of the part to be cleaned is less than70 millimeters place the plug in the inner container’s top hole.If the height of the parts to be cleaned is 70 millimeters orgreater, place the plug in the inner container’s bottom hole.Part height less than 70 millimeters (mm)Outer container filled to 1.3 litersInner container with drain plug in top holeExtended build table hanger7.4 Placing the parts in the inner container3D printed parts made of cured resin may be cleaned by placingthe parts in the inner container. Parts can be cleaned while stillattached to the Build Table or while resting in the part tray.If any parts to be cleaned are still attached to the Build Table,ensure that the hanging arm is secured to the lid and the BuildTable is snugly tightened to the hanging arm. Use the regularhanging arm if the height of the parts is 70 millimeters orgreater. Use the extended hanging arm if the height of the partsis less than70 millimeters.If any part to be cleaned is not attached to the Build Table, thispart shall rest in the part tray.If all parts to be cleaned are still attached to the Build Table, thepart tray shall be removed.Part height 70 millimeters (mm) or greaterOuter container filled to 2.0 litersInner container with drain plug in bottom holeNormal build table hangerCAUTIONOnly 3D printed parts made of cured resin shall be washed in the B9Clean. Cleaning anything that is nota resin-based, 3D printed part will void the warranty. |
Related manuals for B9Creations B9Clean
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine