BAC DCV Series Rigging And Installation Instructions
                           | |
Contents
| 
Safety PrecautionsAll electrical, mechanical and rotating machinery constitute a potential hazard, particularly for those not familiarwith its design, construction and operation. Accordingly, adequate safeguards (including use of protectiveenclosures where necessary) should be taken with this equipment both to safeguard the public (including minors)from injury and to prevent damage to the equipment, its associated system and the premises.If there is doubt about safe and proper rigging, installation, operation or maintenance procedures, contact theequipment manufacturer or his representative for advise.When working on operating equipment, be aware that some parts may have an elevated temperature. Anyoperations on elevated level have to be executed with extra care to prevent accidents.AUTHORIZED PERSONNELThe operation, maintenance and repair of this equipment should be undertaken only by personnel authorized andqualified to do so. All such personnel should be thoroughly familiar with the equipment, the associated systemsand controls and the procedures set forth in this and other relevant manuals. Proper care, procedures and toolsmust be used in handling, lifting, installing, operating and repairing this equipment to prevent personal injury and/orproperty damage.MECHANICAL SAFETYMechanical safety of the equipment is in accordance with the requirements of the EU machinery directive.Depending upon site conditions it also may be necessary to install items such as screens, ladders, bottomscreens, safety cages, stairways, access platforms, handrails and toe boards for the safety and convenience ofthe authorized service and maintenance personnel.At no time this equipment should be operated without all fan screens in place.Since the equipment operates at variable speeds, steps must be taken to avid operating at or near the installation's"critical speed";For more information consult your local BAC Balticare representative.ELECTRICAL SAFETYEach fan associated with this equipment should be installed with a lockable disconnect switch located within sightof the equipment. No service work should be performed on or near the fans unless motors are electrically isolated.LOCAL REGULATIONSInstallation and operation of cooling equipment may be subject of local regulations, such as establishment of riskanalysis. Ensure regulatory requirements are consistently met.W W W . B A L T I M O R E A I R C O I L . E U6 |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine