BALAY 3VS950IA Instructions For Use Manual

Also see for 3VS950IA: Instructions

BALAY 3VS950IA Instructions For Use Manual Manual pdf 17 page image

en17Remaining running time displayWhen the programme is selected, theremaining running time of the programmeis indicated on the digital display 3 .The running time is determined during theprogramme by the water temperature, thenumber of utensils as well as the degreeof soiling and may vary (depending on theselected programme).Display windowApart from information on the programmesequence, the display window 12 alsoindicates additional information one.g. glass protection system is active.If you would no longer like to have thisadditional information displayed, proceedas follows.Open the door.Switch on ON/OFF switch 1 .Hold down programme button Aand press START button 10 until onthe digital display is indicated.Release both buttons.The LED for button A flashes andthe digital display displays the factorysetting .Press programme button A until thefactory set value is indicated onthe digital display 3 .To change the setting,By pressing the C button, you canswitch the onboard computer(additional programme information)off or on .Press START button 10 .The set value is saved.Close the door.Timer programmingYou can delay the start of the programmein 1-hour steps up to 24 hours.Open the door.Switch on ON/OFF switch 1 .Press 8 + button until the timerprogramming display 7 jumps to .Press 8 + or – button until thedisplayed time corresponds with yourrequirements.Press START button 10 , timerprogramming is activated.To delete timer programming, pressthe 8 + or – button untilis indicated on the digital display 7 .You can change your programmeselection at any time until theprogramme starts.Close the door.End of programmeThe programme has ended when thevalue is indicated on the numericaldisplay 3 .The end of the programme is alsoindicated by an acoustic signal.This function can be changed as follows:Open the door.Switch on ON/OFF switch 1 .Hold down programme button Aand press START button 10 until onthe digital display is indicated.Release both buttons.The LED for button A flashes and thedigital display displays the factorysetting .Press programme button A until thefactory set value is indicated onthe digital display .To change the setting,press programme button C .Each time the button is pressed, the setvalue increases by one level; when thevalue of has been reached, thedisplay jumps back to (off).Press START button 10 , the set valueis saved.Close the door.