BALAY 3VS950IA Instructions For Use Manual

Also see for 3VS950IA: Instructions

BALAY 3VS950IA Instructions For Use Manual Manual pdf 25 page image

en25Do not install the appliance near heatsources (radiators, heat storage tanks,cookers or other appliances whichgenerate heat) and do not install undera hob.After installing the appliance, ensurethat the plug is easily accessible.Some models:The plastic housing on the waterconnection contains an electric valve,the connecting cables are in the supplyhose. Do not cut through this hose,do not immerse the plastic housingin water.WarningIf the appliance is not in a cavity anda side panel is accessible, the door hingearea must be covered at the side forreasons of safety (risk of injury).The covers are available as optionalaccessories from customer serviceor specialist outlets.DeliveryYour dishwasher has been checkedthoroughly in the factory to ensure that itis in working order. This may cause smallwater stains. These will disappear after thefirst wash cycle.InstallationThe required installation dimensions canbe found in the installation instructions.Level the appliance with the aid of theheight-adjustable feet. Ensure that theappliance is situated securely on the floor.A built-under or integrated appliancewhich is installed subsequently asa free-standing appliance must besecured to prevent it from overturning,e.g. by screwing it to the wall or byinstalling it under a continuous worktopwhich is screwed to adjacentcupboards.The appliance can easily be installedin a fitted kitchen between wooden andplastic walls. If the plug is not freelyaccessible following installation,an allpole disconnector with a contactopening of at least 3 mm must be fittedon the installation side to satisfy therelevant safety regulations.Waste-water connectionThe required work sequence can befound in the installation instructions.If required, fit a siphon with an drainageconnection.Connect the waste-water hose to thedrainage connection of the siphon withthe enclosed parts.Ensure that the drainage hose is notkinked, crushed or twisted and thatthere is no cover plate in the drainageto prevent the waste water from flowingout!Fresh-water connectionConnect the fresh-water connectionto the tap according to the installationinstructions with the enclosed parts.Ensure that the fresh-water connectionis not kinked, crushed or twisted.When replacing the appliance,always use a new water supply hose.Water pressure:at least 0.05 MPa (0.5 bar), maximum1 MPa (10 bar). At a higher waterpressure: connect pressure-reducingvalve ahead.Inlet rate:minimum 10 litres/minuteWater temperature:cold water preferred; hot water max.temp. 60 C.