BALAY 3VW300IA Instruction Manual

BALAY 3VW300IA Instruction Manual Manual pdf 16 page image

en16Timer programming ** depending on modelYou can delay the start of the programmeby 3, 6 or 9 hours.– Switch on ON/OFF switch (.– Keep pressing the Preselected startingtime button H until the appropriatedisplay 3h, 6h or 9h is lit.– Press START button @, timerprogramming is activated.– To delete the preselected starting time,keep pressing the Preselected startingtime button H until none of thedisplays 3h, 6h or 9h is lit.You can change your programmeselection at any time until theprogramme starts.End of programmeThe programme has ended when the Enddisplay )" is lit.Switching off the applianceShort time after the end of the programme:– Switch off ON/OFF switch (.– Turn off the tap (not applicable if Aqua-Stop fitted).– Remove the utensils when they havecooled down.ã=WarningAt the end of the programme please openthe door fully and not partially whenemptying the dishwasher. Any escapingwater vapour could damage sensitiveworktops.Interrupting the programme– Switch off ON/OFF switch (.The LEDs go out. The programme issaved.If the door was opened on anappliance which has a warm waterconnection or is heated, first leave thedoor ajar for several minutes and thenclose. Otherwise, expansion (pressure)may cause the appliance door tospring open or water to run out of theappliance.– To continue the programme, switch onthe ON/OFF switch ( again.Terminating the programme(Reset)– Press START button @ for approx.3 sec.The End display )" is lit.– The remaining programme sequencelasts approx. 1 minute.Switch off ON/OFF switch (.Changing the programmeWhen the START button @ has beenpressed, the programme cannot bechanged.The only way a programme can bechanged is by Cancel programme (Reset).Intensive dryingThe final rinse uses a higher temperaturewhich improves the drying result. Therunning time may increase slightly.(Caution if utensils are delicate!)– Close the door.– Switch on ON/OFF switch (.– Press and hold down the STARTbutton @.– Rotate programme selector 8 untilthe “Check water supply” display hflashes.– Release button.To change the setting,– By rotating the programme selector8, you can switch on intensivedrying (End display)" is lit) or switchoff intensive drying (End display )" isnot lit).– Press START button @.The setting is saved.