Baby Lock Aventura BLMAV Instruction And Reference Manual

Also see for Aventura BLMAV: Quick reference guide Design guide

Contents

Baby Lock Aventura BLMAV Instruction And Reference Manual Manual pdf 178 page image

Care and MaintenanceA-2Restrictions on oilingIn order to prevent damaging this machine, it must not beoiled by the user.This machine was manufactured with the necessary amountof oil applied to ensure correct operation, making periodicoiling unnecessary.If problems occur, such as difficulty turning the handwheel oran unusual noise, immediately stop using the machine, andcontact your authorized Baby Lock retailer.Precautions on storing the machineDo not store the machine in any of the locations describedbelow, otherwise damage to the machine may result, forexample, rust caused by condensation.• Exposed to extremely high temperatures• Exposed to extremely low temperatures• Exposed to extreme temperature changes• Exposed to high humidity or steam• Near a flame, heater or air conditioner• Outdoor or exposed to direct sunlight• Exposed to extremely dusty or oily environmentsCleaning the LCD ScreenIf the screen is dirty, gently wipe it with a soft, dry cloth. Donot use organic solvents or detergents.Cleaning the machine surfaceIf the surface of the machine is dirty, lightly soak a cloth inneutral detergent, squeeze it out firmly, and then wipe thesurface of the machine. After cleaning it once with a dampcloth, wipe it again with a dry cloth.Cleaning the raceSewing performance will suffer if lint and dust collects in thebobbin case, therefore, it should be cleaned regularly.aPress (Needle position button) to raise the needle.bTurn off the machine.cUnplug the power cord from the power supply jack onthe right side of the machine.dRaise the presser foot to remove the needle, presserfoot and presser foot holder.• For details, refer to “Replacing the needle” and“Replacing the presser foot” in the “Basic operations”section.eRemove the flat bed attachment or the embroidery unitif either is attached.Chapter 1 MAINTENANCE ANDTROUBLESHOOTINGCare and MaintenanceNote• In order to extend the life of this machine,periodically turn it on and use it.Storing this machine for an extended period oftime without using it may reduce its efficiency.Note• Do not wipe the LCD screen with a damp cloth.Memo• Occasionally, condensation may form on the LCDscreen or it may become fogged up; however, thisis not a malfunction. After a while, the cloudinesswill disappear.CAUTION• Unplug the power cord before cleaning themachine, otherwise injuries or an electricshock may occur.CAUTION• Unplug the power cord before cleaning themachine, otherwise injuries or an electricshock may occur.