Baby Lock Pearl BLQF Assembly Instructions Manual

Contents

15Fig. 5-2QF09318-02Fig. 5-3QF09318-02Fig. 5-1QF09318-02Step 7Track Assembly7-3: To prepare for joining the sectionstogether, screw one M5x8mm QF09318-304into the third hole from the splice end of eachsection to serve as a stop screw. (Figs. 7-1,7-2) Fully tighten the screw with the 3mmAllen wrench. This will help align the couplerproperly into the two track support sectionswhen joined.7-4: Insert a coupler into one prepared end ofone track support section up to the stop screw.Thread an M5x8mm QF09318-304 into the firsthole and lightly tighten as shown in Fig. 7-2.Step 7: Track AssemblyParts needed1-Frame Assembly4-Track Support2-Track Support Couple12- M5x8mm Socketed Button Head Cap ScrewQF09318-30412-M6x12mm Socketed Washer Head CapScrew QF09318-3034- Black TrackTools Required3mm Allen Wrench (provided)4mm Allen Wrench (provided)7-1: Place the four (4) track supports,removed earlier, on the frame assembly topwith the screw holes up and the wide lip of thesupports facing the outside of the table.(Fig. 7-1)7-2: Check inside the ends of the tracksupports for burrs or debris and remove allforeign matter from the inside.Track Support shown upside down.Second HolePlace the track supportupside down with the liptoward the outside of thetable.First HoleThird Hole forstop screwsStop Screws M5 x 8mm SBHCS QF09318-304in Third HoleEnd SectionFig. 7-1Fig. 7-2End Section CouplerFirst Hole