BabySense V35TX User Manual

Contents

BabySense V35TX User Manual Manual pdf 9 page image

• Never place the Baby Unit inside the crib, bed or playpen.• Make sure the unit, cords and mains adaptor are out of reach of the baby and other young children.• To avoid a strangula�on hazard, the power cords should be secured and never be hung on the crib ornear the baby.• Place the baby monitor in a place where the air can circulate freely and avoid blocking the ven�la�onand speaker openings.• Aim the camera(s) to best op�mize the viewing area: Select a loca�on for the camera that provides aclear view of the area you want to monitor, which is free from dust, and is not in line-of-sight to a stronglight source or direct sunlight. Avoid installing the camera where there are thick walls or obstruc�onsbetween the camera and the monitor.• To use your parent unit and baby unit together, you must be able to establish a radio link between them;the range may be affected by environmental condi�ons/obstacles (See more details in Troubleshoo�ngSec�on on page 13 - “Interference or poor recep�on”)4 Opera�ng the Monitor4.1 Pairing the Baby Unit (Camera) with the Parent UnitThe Baby Unit is paired to the Parent Unit when supplied. There is no need to pair the units again unlessthe Baby Unit loses its link with the Parent Unit. To renew the pairing of your units or pair a new/addi�on-al Baby Unit, follow the procedure below:NOTE: Before you begin pairing, be sure to have the Baby and Parent Units side by side and turned on.• Press the MENU/OK bu�on (6) on your Parent Unit and the menu screen will pop up.• Press the LEFT bu�on (9) or RIGHT bu�on (7) un�l the PAIR icon is highlighted in red.• Then press the MENU/OK bu�on (6) and a secondary menu with camera op�ons will pop up.• Press the LEFT bu�on (9) or RIGHT bu�on (7) to select the desired Baby Unit to pair and press theMENU/OK bu�on (6) bu�on to start searching for a Baby Unit to pair.• The chosen Baby Unit will start blinking. Press and hold the PAIR bu�on (25) in the back of Baby Unitun�l the connec�on is established.• Once paired, an image from the paired Baby Unit will display on the screen.• Press the EXIT bu�on (8) to exit the menu.• If unsuccessful, please repeat above steps.NOTE: If there is more than one Baby Unit to be paired, repeat the above steps for each one individually.4.2 Switching between the paired Baby Units (Cameras)NOTE: This func�on is only available when two or more cameras are paired.• To switch between the paired cameras, press the MENU/OK bu�on (6) on your Parent Unit and themenu screen will pop up.• Press the LEFT bu�on (9) or RIGHT bu�on (7) un�l the CAM icon is highlighted in red.• Then press the MENU/OK bu�on (6) and a secondary menu with camera op�ons will pop up.• Press the LEFT bu�on (9) or RIGHT bu�on (7) to select the desired Baby Unit you want to connect toand press the MENU/OK bu�on (6) bu�on to confirm.• Image from the selected Baby Unit will display on the screen.• On the top of the LCD display you will see the number of the Baby Unit it is connected to.• Press the EXIT bu�on (8) to exit the menu.9