Bacharach Fyrite Tech 50 Instruction, Operation & Maintenance

Also see for Fyrite Tech 50: Instructions Product catalog Quick start guide Operating and maintenance instructions

Bacharach Fyrite Tech 50 Instruction, Operation & Maintenance Manual pdf 28 page image

Instruction 24-942822Fyrite Tech4.8 Screen Descriptions4.8.1 Warm-Up ScreensAs soon as the analyzer s turned ON, a seres of Warm-Up Screens aredsplayed. These screens show the analyzer’s model number (Tech 50 orTech 60), the unit’s software revision, and finally the remaining warm-uptme counted down from 60 seconds. At the end of warm-up, the analyzerdsplays the Fuel Screen (refer to Secton 4.8.2).Note: If any errors were detected during warm-up, theSensor Error Screen is displayed (refer to Section 4.8.9).4.8.2 Fuel ScreenThe Fuel Screen s dsplayed after warm-up, or can be accessed from anyRun Mode Screen by holdng down the ENTER button for 2 seconds. TheFuel Screen s where an operator chooses whch fuel s to be used by theanalyzer to calculate combustion efficiency. Use the  or  button to scrollthrough the fuel codes untl the desred fuel s dsplayed, and then pressENTER to select the dsplayed fuel and place the analyzer nto ts RunMode. Note that the fuel code wll be dsplayed n the top rght corner of allscreens whle n the Run Mode.Fuel Codes: F1 = Natural GasF2 = Ol #2F3 = LPGF4 = KeroseneFront Panel Button Functions: /  – Scroll through fuel codesENTER – Select fuel and enter Run Mode (refer to Secton 4.7)HOLD – No effectLIGHT – Toggles backlght ON/OFFI/O – Turns analyzer OFF (no delay)