Bacharach MultiZone Installation & Operation Manual
Also see for MultiZone: Instruction
                                                                                    | |
Contents
| 
Multi-Zone Gas Monitors32 P/N: 3015-5074 Rev 114.2.3. Di stance + EXHThis parameter defines the combined length of the sample tubing plus any tubing on the exhaust port. Totallength should not exceed 1200 ft.1. Press the ENTER key to adjust the setting.2. Use the LEFT/RIGHT cursor keys to move across the entry field and the UP/DOWN cursor keys tomodify the individual characters.3. Press ENTER to accept the new entry or ESC to revert to the previous setting.4.2.4. Temp @ ZoneThis parameter is used to set the expected temperature of the air at the zone being sampled. The value isused to calculate the STP PPM value shown in the diagnostic screen only.1. Press the ENTER key to adjust the setting.2. Use the LEFT/RIGHT cursor keys to move across the entry field and the UP/DOWN cursor keys tomodify the individual characters.3. Press ENTER to accept the new entry or ESC to revert to the previous setting.4.2.5. Current Detection ReadingThis reading displays the current PPM level of the selected gas.4.2.6. Log IntervalThe MZ retains a data log of 100 measurements for each zone. The log interval is the number of minutesfrom 1 to 1440 between each log point. This parameter can be changed from Zone Setup Screen #1.The default setting for this parameter is 10 minutes. If the log interval time is set to 0, then a measurement isrecorded in the trend log after every measurement cycle. Therefore, after the trend log is filled, it will containthe last 100 measurement points for a zone. If you want the data logged less frequently, increase thisvalue. It is important to remember that cycle time is dependent on many factors, including the number ofzones monitored, input line length, and the run zeroing mode selected. Before changing this value it may beuseful to first review the log data using the Trend Screen to determine the nominal cycle time.4.3. Navigating to the 2 nd Zone Setup ScreenSelect the MORE option at the bottom right side of the first Zone Setup screen to continue to the nextscreen containing more options. This screen displays the peak PPM value in the upper left side of thescreen.Figure 4-2. Navigating from the First to the Second Zone Screen |
Related manuals for Bacharach MultiZone
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine