Baker BX User Manual
                            | |
Contents
| 
Baker Band Resaw - Rev 1, 09/08; WWW.BAKER-ONLINE.COM21FEEDWORKSFeed SpeedWhen the Feedworks Start/Stop Knob is pushed down, the Feedworks is stopped. To startthe Feedworks, pull the knob up.Note: Always make sure the Feedworks Start/Stop Knob is down (off) when starting the saw.The feed speed can be adjusted from 0 to 95feet per minute with the Feed Speed ControlArm located on the backside of the head rig.When the arm is pointed down, theFeedworks should be motionless. As youswing the arm up, the feed speed willincrease. The arm can be locked into placewith the knob located on the arm. Make surethis knob is loosened when you wish to movethe arm. You will want to experiment to findthe best speed to run your wood types.HydraulicsThe Feedworks uses a hydraulic pump driven off of the main drive motor. Dextron IITransmission fluid is recommended.Conveyor BeltsIf the conveyor belts ever need to be adjusted or replaced, use the belt extenders on the in-feed end of the machine. Each conveyor has two belt extenders on the in-feed end (one oneach side). These should be used to tighten or loosen the belt conveyor.These adjustments should also be used to align the belt. With the Feedworks empty and inmotion, adjust one side until the belt is tracking perfectly.Loosen locking bolts toallow for adjustmentsRe-tighten when finishedFeed SpeedControl ArmHydraulic FluidReservoirHydraulicFluid FilterFeedworksStart/StopFigure J: Feedworks AssemblyTurn indexer nut to tightenbelt or adjust belt trackingFigure K: Conveyor Belt Adjuster Arm (one on each side) |
Related manuals for Baker B
manualsdatabase
Your AI-powered manual search engine