Masoneilan SVI II AP Installation and Maintenance Manual =| 91© 2017 Baker Hughes, a GE company, LLC. All rights reserved.Configuration with Pushbutton DisplayPrior to changing the SVI II AP configuration, check the existing configuration.Verify that the mounting has not been damaged in shipment for a pre-mounted SVI II AP.Record the following information for the configuration checkout: Valve Air to Open (ATO) or Air to Close (ATC) Actuator pressure rating Actuator bench range Inherent trim characteristic of the control valve; linear, equal percentage, or other.Refer to valve data sheet or model number of control valve.Viewing Configuration DataTo view SVI II AP configuration data:1. Access the VIEW DATA menu from the MANUAL menu by pressing the + button.2. In the VIEW DATA menu, press * to examine the configuration.3. Press + to scroll through and observe the factory configuration.4. Press * to exit VIEW DATA.5. Press + untilMANUAL appears.6. Press * to enter MANUAL mode.7. Press any key to make MAN POS appear.8. When the adjustment screen appears stroke the valve open by holding + down. Noticethat the rate of set point change is slow to begin, but increases speed while the + ispressed.9. Stroke the valve to several values.10. Verify the action is as desired.11. Press * to exit MAN POS mode.12. Press + to move to the SETUP menu.13. In the SETUP menu press the * button to access the CONFIGuration menu.14. In the CONFIG menu set the configuration parameters.15. When in CONFIGure or CALIBrate, pressing * changes values.16. Return to NORMAL mode. The valve moves to the Value set by the current calibrator.17. Stroke the valve through its range to verify that the movement is as desired.
