Bakers Pride VH1620E Installation And Operating Instructions Manual

Also see for VH1620E: Parts list Installation and operating instructions Installation and operating instructions

Contents

Bakers Pride VH1620E Installation And Operating Instructions Manual Manual pdf 2 page image

2! WARNING: This symbol refers to a potential hazard or unsafe practice, which could result inserious injury or death. !!! DANGER: This symbol warns of imminent hazard which will result in serious injury or death.!! CAUTION: This symbol refers to a potential hazard or unsafe practice, which may result in minor ormoderate injury or product or property damage.!! NOTICE: This symbol refers to information that needs special attention or must be fully understoodeven though not dangerous.GENERAL INFORMATIONTHIS MANUAL SHOULD BE RETAINED FOR FUTURE REFERENCEBakers Pride takes pride in the design and quality of our products. When used as intended and with propercare and maintenance, you will experience years of reliable operation from this equipment. To ensure bestresults, it is important that you carefully read and follow the instructions in this manual.Installation and start-up should be performed by a qualified installer who has thoroughly read, understandsand follows these instructions.If you have questions concerning the installation, operation, maintenance or service of this product, contactour Technical Service Department at (800) 431-2745.Before installing and operating this equipment be sure everyone involved in its operation are fully trainedand are aware of all precautions. Accidents and problems can result by a failure to follow fundamental rulesand precautions.The following words and symbols, found in this manual, alert you to hazards to the operator, servicepersonnel or the equipment. The words are defined as follows:SAFETY PRECAUTIONS!CAUTION: These models are designed, built, and sold for commercial use. If these models arepositioned so the general public can use the equipment make sure that cautions, warnings, andoperating instructions are clearly posted near each unit so that anyone using the equipment willuse it correctly and not injure themselves or harm the equipment.!!WARNING: Check the data plate on this unit before installation. Connect the unit only to the voltageand frequency listed on the data plate. Connect only to 1 or 3 phase as listed on the data plate.!!! WARNING: Electrical and grounding connections must comply with the applicable portions of thenational electrical code and/or other local electrical codes.!! WARNING: Disconnect device from electrical power supply and place a Tag Out-Lockout on thepower plug, indicating that you are working on the circuit.WARNING: Install per the spacing requirements listed in the installation section of this manual. Westrongly recommend having a competent professional install the equipment. A licensed electricianshould make the electrical connections and connect power to the unit. Local codes should alwaysbe used when connecting these units to electrical power. In the absence of local codes, use thelatest version of the National Electrical Code.!!!!WARNING: This device should be safely and adequately grounded in accordance with localcodes, or in the absence of local codes, with the National Electrical code, ANSI/NFPA 70, LatestEdition to protect the user from electrical shock. It requires a grounded system and a dedicatedcircuit, protected by a fuse or circuit breaker of proper size and rating. Canadian installation mustcomply with the Canadian Electrical Code, CSAC22.2, as applicable