Bakers Pride VH1620E Installation And Operating Instructions Manual

Also see for VH1620E: Parts list Installation and operating instructions Installation and operating instructions

Contents

Bakers Pride VH1620E Installation And Operating Instructions Manual Manual pdf 5 page image

53. INSTALLATIONPlace the conveyor oven and parts as close to the area of final installation before uncrating. Your conveyoroven is packed sitting on its bottom. Leave it this way until unpacked. The pallet may be left under theconveyor oven for convenience in further handling. Unpack carefully to avoid damage to the unit. Ifconcealed damage is discovered, follow the instructions detailed in Section 1 above.A. Legs are shipped unattached. Make sure each leg is attached and tightened before placing theconveyor oven in place. Each leg is adjustable to accommodate variations in the mounting surface.B. Using sufficient help (2 or more people), lift the conveyor oven upward and place on the countertopsurface. Lift the conveyor oven by gripping the bottom of the unit. THE FOLLOWING ITEMS ARENOT TO BE USED AS LIFTING "HANDLES": Side-mounted control boxes (2), removable front door(with handles), the conveyor belt assembly, the rear fan housing assembly.C.See Section 6a, b for further instructions.D. Position the conveyor oven in its final location, maintaining the minimum clearances specified inSection 2 above.DO NOT LIFT EXCESSIVE WEIGHTTHE CONVEYOR BELT ASSEMBLY IS MOUNTED BACKWARDS FOR SHIPPING. THECONVEYOR BELT ASSEMBLY MUST BE REMOVED AND REVERSED PRIOR TO OPERATION.I. INSTALLATION INSTRUCTIONS1. RECEIVING2. LOCATION AND MINIMUM CLEARANCESVH1620E 6.4 1 or 3VHVA1620E 6.4 1 or 3VH1828E 12.4 1 or 3VHVA1828E 12.4 1 or 3Read the notice on the outside carton regarding damage in transit. "CONCEALED DAMAGE", damagediscovered after opening the crate(s), MUST be reported immediately to the carrier. The carrier will performan inspection of the damage and furnish forms for the consignee's claim against the carrier. Retain ALLpackaging material - including outer carton, until the inspection has been completed.Proper and secure storage facilities should be arranged for the conveyor oven(s) if necessary to protect itfrom outdoor or damp conditions at all times prior to installation.Adequate air space must be provided for the proper venting of the rear exhaust air and provision made forventing of cooking vapors. The Conveyor Oven must be installed in a well-ventilated area.Attached rear rubber bumpers must not be removed and can contact a rear wall if present.Conveyor Ovens can be installed with "ZERO" clearances (back and sides) from combustible and non-combustible materials. (Rear rubber bumpers are the “Zero” clearance points on the back of the unit.) S e erating plate attached to the control box door panel.The Conveyor Oven is intended for countertop mounting if mounted on the 4" legs provided. The Oven isNOT approved for mounting on any floor. Keep the area around your conveyor oven free and clear of allcombustible materials.NOTE:MODELS COVERED TOTAL KW PHASE