Bakers Pride Vantage 100 Series Technical & Service Manual

Also see for FC-516: Production chart Catalog Specifications Design & installation guide Installation and operating instructions

Contents

Bakers Pride Vantage 100 Series Technical & Service Manual Manual pdf 12 page image

FLOOR MODEL GAS DECK OVEN SERVICE MANUAL10Pilot Lighting And AdjustmentsMost ovens have a combination valve that supplies gasto the pilot burner. Some ovens have a pilot safety valve.The basic method is the same for each.The 7000 combination valve has a dial that controls thegas flow. Turn it to “PILOT”. The pilot safety valve has aRED button.Turn the gas supply to the oven ON.Slightly depress and turn the combination gas cockknob to the PILOT position.Depress the dial or the red button and hold. It may takeseveral minutes to bleed air from the tubing supplyinggas to the pilot burner.Apply a flame to the pilot burner to light. Continue tohold the dial/button depressed for at least 30 secondsfor the flame to be sensed by the valve.After letting go of the dial/button if the pilot flame goesout repeat the above steps.Once the flame is lit and burning normally for severalminutes to insure all air is bled from the supply tube theflame may need to be adjusted. On pilot safety valvesthere is an adjustment screw above the red button. Oncombination valves there is an adjustment screw atthe top left corner of the valve body. Remove the pilotadjustment cap.Using a small flat blade screwdriver turn the screwcounter-clockwise to reduce the size of the flame. Turnthe screw clockwise to increase the size of the flame.The flame should be approximately 3/8 in to 1/2 in highand wrap around the flame sensor bulb.FLAME AND BURNER ADJUSTMENTSFlame And Air Mixture AdjustmentsLight the burners and turn the thermostat dial to thedesired temperature setting. Allow the flame to burn fora few minutes to settle.Observe the burner flame. The flame should be sharplyformed cone shapes that are blue in color. If your fuelsource is propane there may be yellow tips that flickerbriefly.If the flame is not formed, is lazy, and has a lot of yellowcolor, not enough air is mixing with the gas. If theflame “roars” and you can see the base of the flameseparating from the burner pipe– lifting, there is toomuch air mixing with the gas. For either condition theair/fuel mixture must be adjusted.Pilot Safety Valve7000 Valve