Baldor BC142 Installation And Operation Manual

Also see for BC141: Installation & operating manual

Baldor BC142 Installation And Operation Manual Manual pdf 23 page image

10 RECOMMENDED HIGH VOLTAGE DIELECTRIC WITHSTAND TESTING (Hi-Pot Testing)Testing agencies such as UL, CSA, etc., usually require that equipment undergo a hi-pot test. In order to preventcatastrophic damage to the control, which has been installed in the equipment, it is recommended that the follow-ing procedure be followed. A typical hi-pot test setup is shown in Figure 13 on page 23. All controls have beenfactory hi-pot tested in accordance with UL requirements.WARNING! When performing the hi-pot test, disconnect the AC power.2290 - 130 VoltDC Motors(HP)180 VoltDC Motors(HP)ApproximateMotor Current(Amps DC)Plug-In HorsepowerResistor® and ArmatureFuse Kit Catalog No.Plug-In HorsepowerResistor®Value (Ohms)ArmatureFuse Rating(Amps)1/100 1/50 .2 BR1000 1 .51/50 1/25 .3 BR0510 .51 .51/30 1/15 .33 BR0350 .35 .51/20 1/10 .5 BR0250 .25 .751/15 1/8 .8 BR0251 .25 11/12 1/6 .85 BR0180 .18 1.251/8 1/4 1.3 BR0100 .1 21/6 1/3 2 BR0101 .1 2.51/4 1/2 2.5 BR0050 .05 41/3 3/4 3.3 BR0035 .035 51/2 1 5 BR0025 .025 83/4 11⁄2 7.5 BR0015 .015 121* 2* 10 BR0010 .01 1511⁄2* 3* 15 BR0006 .006 25* Indicates an Auxiliary Heat Sink (Catalog No. BC143, or equivalent) must be used.TABLE 5 – PLUG-IN HORSEPOWER RESISTOR® & ARMATURE FUSE KIT SELECTION!