Balluff BNI EIP-306-100-Z010 User Manual

Contents

Balluff BNI EIP-306-100-Z010 User Manual Manual pdf 19 page image

Balluff Network Interface EtherNet/IP™www.balluff.com 187 Display7.5. IP Configuration1. Long-time key press on set key starts editing mode.2. Configuration of the selected value by short-time key press on arrow-key3. After configuration store the new value by long-time keypress on set-key.NoteTo work with the new configuration, the module needs a power-down-reset.NoteIf a value has been changed, but the “old” address is still in use, the display showsan “unequal” symbol.7.6. GeneralInformation Differences between new configuration and the configuration the module is workingwith are shown by a unequal-symbol. In editing mode the screen flashes If the module receives a single ping, the word “ping” is shown in the display screenfor a few seconds. Afterwards the screen is reset to the screen which had beenshown before. By short-time key press on set key the ping-mode can be leftpreterm. The Led function at the display LEDs can be defined user specific by setting somebits in the process data inputs. (see “Process Data Outputs”) The function plc-lock can also be used by setting a bit in the process data inputs.(See “Process Data Outputs”)Note:Editing Mode can not be chosen in display if the plc lock bit in process datainputs is set. (see “Process Data Outputs”)001 005S S005editing mode

/ 22

Related manuals for Balluff BNI EIP-306-000-Z010