Balluff BNI EIP-508-005-E002 User Manual

Also see for BNI EIP-507-005-Z040: Installation guide

Balluff BNI EIP-508-005-E002 User Manual Manual pdf 19 page image

Balluff Network Interface EtherNet/IP™www.balluff.com 185 IntegrationPossible values of MasterCycleTime and MiniCycleTimeTime baseencodingTime Basevalue Calculation Cycle Time00 0.1 ms Multiplier x Time Base 0.4 ms to 6.3 ms01 0.4 ms 6.4 ms + Multiplier x Time Base 6.4 ms to 31.6 ms10 1.6 ms 32.0 ms + Multiplier x Time Base 32.0 ms to 132.8 ms11 Reserved Reserved ReservedNOTE: The value 0.4 results from the minimum possible transmission time according toA.3.7.ValidationSettingsNo validation: validation deactivated, every device will be accepted.Compatibility: manufacturer ID and device ID are compared to the IO-Link device data.Identity: manufacturer ID and device ID and serial number are compared to theIO-Link device data. The IO-Link communication is only started if there is a match.Parameter Server Enable: data management functions enabled, parameter data and identification data of theIO-Link device are stored permanently.Disable: data management functions disabled, stored parameter data and identificationdata of the IO-Link device remain stored.Deleted: data management functions disabled, stored parameter data and identificationdata of the IO-Link device are deleted.Enable upload:If only the upload is enabled, the master always starts an upload of the parameter data. Inthis case, the upload is independent of the upload flag of the IO-Link device. If no data isstored in the Master Port, an upload likewise takes place. (e.g. after deleting the data orbefore the first data upload)Enable download:If only the download is enabled, the master always starts a download of the parameter data.In this case, the download is likewise independent of the upload flag of the IO-Link device.If no data is stored in the Master Port, however, an upload takes place first. (e.g. afterdeleting the data or before the first data upload)Enable upload and download:If the upload and download are enabled, different parameter sets are distinguisheddepending on the upload flag of the IO-Link device.If no parameter data is stored in the IO-Link master port, an initial upload takes place.(e.g. after deleting the data or before the first data upload)If the upload flag is set on the IO-Link device, an upload of the parameter data always takesplace.If no upload flag is set and parameter data has already been stored, a download of theparameter data always takes place.