Balluff BNI PNT-502-102-Z015 User Manual

Balluff BNI PNT-502-102-Z015 User Manual Manual pdf 21 page image

www.balluff.com 205 IntegrationInputs pin 4Inputs pin 2Outputs pin 4Outputs pin 2Signal from configured inputs or outputs are depicted in the modules inputs pin 4 /inputs pin 2 and outputs pin 4, outputs pin 2.The "inputs pin 2" module also depicts the diagnostic inputs of the diagnostic input function.IO–Link modules The IO-Link modules always have the same structure:IOL_I/O_x/xBytesNumber of process data items used (should be equal to or greater thanthe process data length of the IO-Link device)I = Input dataO = Output dataI/O = Both input and output dataActuatorshutdown pin 4 /pin 2Depicts a short circuit between a set output to ground at the respective port pin.Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0Port 7Port 6Port 5Port 4Port 3Port 2Port 1Port 0Actuator warningpin 4 / pin 2Feedback if a voltage is being supplied at an output that is not set.Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0Port 7Port 6Port 5Port 4Port 3Port 2Port 1Port 0Restart pin 4 /pin 2If this function is configured, no automatic restart is performed after an actuatorshort-circuit, but rather the port must be activated by inserting the corresponding bit.Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0Port 7Port 6Port 5Port 4Port 3Port 2Port 1Port 0Bit mapping and5.3.functionBit mapping and function of the configurable modules