Bally Refrigerators/Freezers/Warmers Installating And Operation Manual
                                    | |
Contents
| 
- 4 -INSTALLING LEGS AND LEVELING REACH-IN MODELSYour new reach-in model is supplied with adjustable type legs for levelingpurposes. Each single and two section model has four leg mounting holes on itscase bottom, and three section models have six leg mounting holes. Legs arepacked in the accessory carton from which they must be removed and installed onthe cabinet case bottom (see figure 2). In order to install the legs, carefully tip thecabinet rearward adding four (4) 2" wood blocks underneath and simply screw thethreaded leg studs into the case bottom front leg holes. Repeat this procedure bytilting the cabinet in the opposite direction and install the remaining legs. Make surethe legs are tightened extremely well or the entire model will sway or rock with eachopening or closing of the doors, possibly causing damage to the case bottom. Thisprocedure should be performed close to the final installation site and allow accessto the rear of the cabinet for condensate evaporator installation (see "condensateevaporator installation" under installation and location section).To assure your cabinet is level, all legs are equipped with bullet-type leveling bolts.These bolts can be turned by hand or by wrench, clockwise or counterclockwise tolevel the cabinet.FIGURE 2LEG INSTALLATIONMOUNTING ROLL-IN MODELS IN PLACE AND LEVELINGYour new roll-in model is designed and constructed to be mounted directly on thefloor without legs or casters. The floor must be level and the base of the cabinetshould be sealed to the floor around its entire perimeter. If the floor is not level, itmust be made level prior to mounting your roll-in model.Your roll-in model comes with one cart ramp per door opening. To install theramp(s), simply open the cabinet door and position the ramp slots onto the screwslocated along the cabinet bottom front. If the door wiper rubs along the ramp to theextreme where the door will not self-close, you will need to adjust the door (see"door adjustment" section) or level the cabinet as explained above. |
manualsdatabase
Your AI-powered manual search engine