Bally Refrigerators/Freezers/Warmers Installating And Operation Manual
                                    | |
Contents
| 
- 6 -INSTALLING CONDENSATE EVAPORATORNo floor drains or plumbing connections are required since all models use anautomatic condensate water evaporating system. All designer line models utilize aunique hot gas condensate water evaporating system which is completely self-contained and no further assembly or maintenance is required (these models arerecognized by their evaporator coil which is located out of the food zone in aninsulated plug-box housing next to the condensing unit). All value line models aresupplied with an electric condensate evaporator pan and mounting bracket packedin the accessory carton. To install the condensate pan on value line models only,remove both mounting screws located on the bottom of the cabinet back and installthe mounting bracket on the case bottom as shown in figure 4. Slide thecondensate pan onto the bracket, install the drain tube into the pan making sure itis not blocked or kinked, and plug the ten foot power cord into the receptaclelabeled "vaporizer" located on the case top electrical box.IMPORTANT NOTE: It is extremely important to be sure that thecondensate pan is plugged into its correct receptacle labeled "vaporizer" andthat the condensing unit is plugged into its correct receptacle labeled"condensing unit".FIGURE 4CONDENSATE EVAPORATOR INSTALLATION |
manualsdatabase
Your AI-powered manual search engine