Bang & Olufsen BeoVision 9 Manual

Also see for BeoVision 9: Guide Guide

Bang & Olufsen BeoVision 9 Manual Manual pdf 28 page image

Scan in TV channelsUseful hintsNOTE! If you select ‘OFF’ for ‘TV TUNER’, youmust register a source in the ‘CONNECTIONS’menu as ‘TV’ if you wish to switch on the TVusing the TV button on the remote control. See‘Register additional equipment’ on p. 43.1*Signal typeRF cable box2*Channel numberIf you select ‘CABLE’ or ‘ANTENNA’, scanning begins immediately. If youselect ‘CABLE BOX’, register the cable box. See ‘Identify the cable box’on this page.Leave a connected RF cable box switched on at all times.The channel number should correspond to the output channel set on thecable box.Find out how to register the source of your TV signal type and how to scan inyour TV channels.Select video signal typeIf you have selected ‘TV TUNER’ in the ‘TUNERSETUP’ menu, enter the source of your TV videosignal.Highlight ‘TVTUNER‘ in ‘TUNERSETUP’ menuBring up ‘TV SETUP’menu and select‘OPTIONS’Identify the cable boxIf you have connected a cable box to the TV,register the connection in the ‘CABLE BOXSETUP’ menu.Select ‘CH TEST‘Select name of cable boxSelect signal typeand acceptTest if you canchange channelSource for RF inputWhen you have registered the cable box, enterthe output channel for the type of cable boxand test whether you can change channels.Select channelnumber*2Scanning begins/identify cable box*1Store or repeatprocedure26