Quick Start GuideAdvanced sensor with dual digital displays for use with plastic and glass fiber optic assembliesFor complete technical information about this product, including dimensions, accessories, and specifications, seewww.bannerengineering.com and search for your model number. The instruction manual is p/n 161999.WARNING:• Do not use this device for personnel protection• Using this device for personnel protection could result in serious injury or death.• This device does not include the self-checking redundant circuitry necessary to allow its use inpersonnel safety applications. A device failure or malfunction can cause either an energized (on) or de-energized (off) output condition.OverviewFigure 1. DF-G1 Model Features1 Output LED2 LO/DO Switch3 RUN/PRG/ADJ Mode Switch4 Lever Action Fiber Clamp5 Red Signal Level6 Green Threshold7 +/SET/- Rocker ButtonModelsModel Outputs Connector1DF-G1-NS-2M Single NPN2 m (6.5 ft) cable, 4-wireDF-G1-PS-2M Single PNPDF-G1-KS-2M Dual outputs, 1 push-pull IO-Link and 1 PNP(complementary outputs)DF-G1-NS-Q5 Single NPN150 mm (6 in) PVC pigtail, M12 Euro QD connector, 4-pinDF-G1-PS-Q5 Single PNPDF-G1-KS-Q5 Dual outputs, 1 push-pull IO-Link and 1 PNP(complementary outputs)DF-G1-NS-Q7 Single NPNIntegral M8 Pico QD connector, 4-pinDF-G1-PS-Q7 Single PNPDF-G1-KS-Q7 Dual outputs, 1 push-pull IO-Link and 1 PNP(complementary outputs)1 Connector options:• A model with a QD connector requires a mating cordset .• For 9 m cable, change the suffix 2M to 9M in the 2 m model number (example, DF-G1-NS-9M).• For 150 mm (6 in) PVC pigtail, M8 Pico QD connector, 4-pin change the suffix 2M to Q3 in the 2 m model number (example, DF-G1-NS-Q3).DF-G1 Expert™ Dual Display Fiber AmplifierOriginal Document161275 Rev. E21 March 2019161275