Installation GuideAdvanced sensor with dual digital displays for use with plastic and glass fiber optic assemblies.For complete technical information about this product, including dimensions, accessories, and specifications, see http://www.bannerengineering.com and search 161999.OverviewFigure 1. DF-G1 Model Features1 Output LED2 LO/DO Switch3 RUN/PRG/ADJ Mode Switch4 Lever Action Fiber Clamp5 Red Signal Level6 Green Threshold7 +/SET/- Rocker ButtonWARNING: Not To Be Used for Personnel ProtectionNever use this device as a sensing device for personnel protection. Doing so could lead toserious injury or death. This device does not include the self-checking redundant circuitry necessaryto allow its use in personnel safety applications. A sensor failure or malfunction can cause either anenergized or de-energized sensor output condition.ModelsModel Outputs Connector1DF-G1-NS-2M Single NPN2 m (6.5 ft) cable, 4-wireDF-G1-PS-2M Single PNPDF-G1-KS-2M Dual outputs, 1 push-pull IO-Link and 1PNP (complementary outputs)DF-G1-NS-Q5 Single NPN150 mm (6 in) PVC pigtail, M12 Euro QD connector,4-pinDF-G1-PS-Q5 Single PNPDF-G1-KS-Q5 Dual outputs, 1 push-pull IO-Link and 1PNP (complementary outputs)DF-G1-NS-Q7 Single NPNIntegral M8 Pico QD connector, 4-pinDF-G1-PS-Q7 Single PNPDF-G1-KS-Q7 Dual outputs, 1 push-pull IO-Link and 1PNP (complementary outputs)1 Connector options:• A model with a QD connector requires a mating cordset .• For 9 m cable, change the suffix 2M to 9M in the 2 m model number (example, DF-G1-NS-9M).• For 150 mm (6 in) PVC pigtail, M8 Pico QD connector, 4-pin change the suffix 2M to Q3 in the 2 m model number (example, DF-G1-NS-Q3).DF-G1 Expert™ Dual Display Fiber AmplifierOriginal Document161275 Rev. D9 September 2015161275