Banner PTL110S Instruction Manual

Contents

Banner PTL110S Instruction Manual Manual pdf 13 page image

5 SpecificationsSupply and Voltage Current10 V dc to 30 V dc, UL Listed class 2 power supply1.65 Watts max. power drawMaximum Current155 mA at 10 V dc60 mA at 24 V dc55 mA at 30 V dcCurrent measurements assume indicator is on at high intensity, displayis on, and sensor module is active. Typical device current will bedependent on its configuration. See the Instruction Manual for moreinformation.ConstructionHousing: ABSIndicator: PolycarbonateDisplay Lens: Acrylic (if present)ConnectionsIntegral PVC cable with quick disconnect, length varies depending onmodelEnvironmental RatingIEC IP54CertificationsOperating Conditions–40 °C to +50 °C (–40 °F to +122 °F)90% at +50 °C maximum relative humidity (non-condensing)Required Overcurrent ProtectionWARNING: Electrical connections must bemade by qualified personnel in accordancewith local and national electrical codes andregulations.Overcurrent protection is required to be provided by end productapplication per the supplied table.Overcurrent protection may be provided with external fusing or viaCurrent Limiting, Class 2 Power Supply.Supply wiring leads < 24 AWG shall not be spliced.For additional product support, go towww.bannerengineering.com.Supply Wiring (AWG) Required Overcurrent Protection (Amps)20 5.022 3.024 2.026 1.028 0.830 0.55.1 Dimensions30.1[1.19]3.0[0.12]ø28[1.10]Pipe DiameterM5 x 0.86mm Screw Length Maximum3 N•m Max Torque50.0[1.97]9.0[0.35]2.5[0.10]110.0[4.33]℄69.7[2.74]5.3[0.21]35 mm[1.38”]PTL110S Pick-To-Light Deviceswww.bannerengineering.com - Tel: + 1 888 373 6767 13

/ 16

Related manuals for Banner PTL110S