Banner Sure Cross Performance GatewayPro DX80P*A6 series Instruction Manual

Also see for Sure Cross Performance DX83A: Network manual

Contents

Banner Sure Cross Performance GatewayPro DX80P*A6 series Instruction Manual Manual pdf 8 page image

2 FeaturesThe following feature callouts refer to the DX80 Gateway and Node models, the GatewayPro, and the DX83 EthernetBridge. The wiring diagrams include information for connection power and sensors using the 5-pin Euro-style connect, theterminal wiring board, and the Industrial Ethernet connection on the DX83 and GatewayPro.2.1 DX80 Gateway and Node ComponentsThe DX80 Gateway and Node use the same housing and include the same physical features.12345671. Port, NPT gland, or plug. If unused, install the provided pluginto the 1/2 NPT threaded port. Refer to the Installationsection if an IP67 seal is required.2. Rotary switch 1 (left). Sets the Network ID (NID) to ahexidecimal value from 0 to F, for a total of 16 Network IDs. AGateway and its corresponding Nodes must be assigned thesame Network ID.Rotary switch 2 (right). On the Gateway, sets the Gateway’sLCD viewing device address. The Gateway is predefined asDevice Address 0. On the Node, sets the Node’s DeviceAddress (hexidecimal 1 to F). Each Node within a networkmust have a unique Node Device Address.3. Push button 1. Single-click to advance across all top-levelDX80 menus. Single-click to move down interactive menus,once a top-level menu is chosen. Button 1 is also used to wakeintegrated battery models from the hibernation mode they shipin.4. Push button 2. Double-click to select a menu and to entermanual scrolling mode. Double-click to move up one level at atime.5. LED 1 and 2. Provide real-time feedback to the user regarding RF link status, serial communications activity, and theerror state.6. LCD Display. Six-character display provides run mode user information and shows enabled I/O point status. Thisdisplay allows the user to conduct a Site Survey (RSSI) and modify other DX80 configuration parameters without the useof a PC or other external software interfaces. On the Node, after 15 minutes of inactivity, the LCD goes blank. Press anybutton to refresh the display.7. 5-Pin M12 Euro-style quick-disconnect serial port2.2 DX80 Gateway and Node Wiring ChamberThe DX80 Gateway and Node use the same housing and terminal block for wiring.123451. Housing. The rugged, industrial DX80 housing meets IECIP67 standards.2. Mounting hold, #10/M5 clearance. Mounting Holes acceptmetric M5 or UNC/UNF #10 hardware -- DIN rail mountadapter bracket available.3. Wiring terminal strip. The 16 spring-clip type wiringterminals accept wire sizes: AWG 12-28 or 2.5 sq mm.4. Port, PG-7 gland or blank. The PG-7 threaded ports canaccept provided cable glands or blanks.5. Ribbon connector. Ribbon cable connects wiring base toLCD/radio.Sure Cross® Performance DX80 Wireless I/O Networks8 www.bannerengineering.com - Tel: 763.544.3164