2 FeaturesThe following feature callouts refer to the DX80 Gateway and Node models, the GatewayPro, and the DX83 EthernetBridge. The wiring diagrams include information for connection power and sensors using the 5-pin Euro-style connect, theterminal wiring board, and the Industrial Ethernet connection on the DX83 and GatewayPro.2.1 DX80 Gateway and Node ComponentsThe DX80 Gateway and Node use the same housing and include the same physical features.12345671. Port, NPT gland, or plug. If unused, install the provided pluginto the 1/2 NPT threaded port. Refer to the Installation sec-tion if an IP67 seal is required.2. Rotary switch 1 (left). Sets the Network ID (NID) to a hexi-decimal value from 0 to F, for a total of 16 Network IDs. AGateway and its corresponding Nodes must be assigned thesame Network ID.Rotary switch 2 (right). On the Gateway, sets the Gateway’sLCD viewing device address. The Gateway is predefined as De-vice Address 0. On the Node, sets the Node’s Device Address(hexidecimal 1 to F). Each Node within a network must have aunique Node Device Address.3. Push button 1. Single-click to advance across all top-levelDX80 menus. Single-click to move down interactive menus,once a top-level menu is chosen. Button 1 is also used to wakeintegrated battery models from the hibernation mode they shipin.4. Push button 2. Double-click to select a menu and to entermanual scrolling mode. Double-click to move up one level at atime.5. LED 1 and 2. Provide real-time feedback to the user regarding RF link status, serial communications activity, and theerror state.6. LCD Display. Six-character display provides run mode user information and shows enabled I/O point status. This dis-play allows the user to conduct a Site Survey (RSSI) and modify other DX80 configuration parameters without the use ofa PC or other external software interfaces. On the Node, after 15 minutes of inactivity, the LCD goes blank. Press anybutton to refresh the display.7. 5-Pin M12 Euro-style quick-disconnect serial port2.2 DX80 Gateway and Node Wiring ChamberThe DX80 Gateway and Node use the same housing and terminal block for wiring.SureCross DX80 and Performance DX80 Product Manual8 www.bannerengineering.com - tel: 763-544-3164 Rev. J
