Barco 2100LC Installation Manual

Also see for RETRO DATA 2100LC: Owner's manual Owner's manual

Contents

Barco 2100LC Installation Manual Manual pdf 6 page image

Installation Set Up2-15975968A RETRO DATA 2100LC 1302982 INSTALLATION SET UPCabinet AssemblyAttention : Avoid touching the screen while handling the screencabinet in order to avoid any damage of the screen surface. Alsoexercise caution not to damage the projector lens when joining thecabinets together.å Lift up the upper mirror cabinet and bring it down vertically ontothe projector lower cabinet.ç Both centering pins on the mirror cabinet must match and lockinto the centering holes in the projector cabinet. Ensure also that thefixing holes in the upper mirror cabinet align with the holes in the lowerprojector cabinet.é Once the cabinets are in place, two cabinet attachment screwsare secured (in the fixing holes) from the rear side of the retroprojector. The third is secured by reaching through the lower cabinet(rear side,) and securing through the far underside of the projectionhole opening. This will require some care in manoeuvring as the fixingis recessed when the two cabinets are in place. Ensure each screwis tightened fully by hand.Attachment of the projector LensCabinet AssemblyAttachment of the Side ProfileMirror PositioningFocusing the LensAttachment of the Projector LensThe projector lens is clamped during transportation inside the lowerprojector cabinet (lower left back side). Exercise care not to scratchor damage the lens when installing.å To fix into position it is necessary to first unclamp the lens, byundoing the clamping screw completely. Lift carefully out by firstpushing it slightly backwards (to clear the clamping hooks) and thenpivoting up the farside of the lens and lifting out.ç Take the lens and place through the projection hole on top of thelower cabinet. The threaded end goes through first. Keep a tight holdof the lens and carefully lower, the lens and projector barrel will meetand the two will screw together.WARNING : ENSURE YOU HAVE REMOVED THE PROTECTIVE PACKING FOAM FROM INSIDETHE PROJECTOR BARREL FIRST.é Screw onto the projector barrel in the clockwise direction ensur-ing good connection. The lens should screw in without resistance,if any resistance is felt (the two screw threads are not aligned) thenuntighten immediately and remove and try once more. Once properconnection is made, screw in the lens approximately three quartersof its length for focusing later.CLAMPINGSCREWPROJECTIONHOLEPROJECTORLENSPROJECTORLENSCLAMPINGHOOKS/(16352-(&7,21+2/(352-(&725%$55(/ç&éååç&éå),;,1*+2/(6&(17(5,1*+2/(6&(17(5,1*3,16RQXQGHUVLGH