Barco 2100LC Installation Manual

Also see for RETRO DATA 2100LC: Owner's manual Owner's manual

Contents

Barco 2100LC Installation Manual Manual pdf 7 page image

Installation Set Up2-2 5975968A RETRO DATA 2100LC 130298Attachment of the side profilesThe side profiles are packed during transportation inside the mirrorcabinet (back side.)å The side profiles are to be attached to the forward front sidesof the upper cabinet.ç To fix in position turn in the screws a little and slide the profile overthe screws, use the three screws provided for each profile.Mirror PositioningThe Upper cabinet contains a mirror for reflecting and projecting theprojector image onto the screen. During shipping or storage the mirroris pivoted into the upper cabinet, and locked by two hand tightablescrews.å To open up the mirror cabinet and locate into the operationalposition it is necessary to remove the two locking screws and pullout the mirror flap fully (as far as possible.)ç While holding the flap fully open, lock in position using the samelocking nuts, but this time screw into the screw holes on the outersides of the cabinet.Focusing can only be achieved through access at the rear of theretro projector, while the projector is in its operational mode. Aprojector internal screen pattern may be used to assist focusing(see Service mode in owners manual.)å Firstly ensure that the outer Front Rotary Lens Ring (a) iscompletely turned in the clockwise direction.ç Loosen the Locking Fastener Ring (c) of the lens by turningcounter clockwise a sufficient amount to allow turning of the MainLens Barrel Tube (b).é Focus the middle region of the screen by turning the Main LensBarrel Tube in the clockwise or anti clockwise direction until thepicture is focused. Attention: Do not turn out the lens to far,otherwise it will fall out of the lens holder. Once the barrel is in thedesired position, lock the Fastener Ring (c) by turning clockwiseuntil fully locked.è It is now necessary to focus the corners of the picture byadjusting the Front Rotary Lens Ring (a), moving the desired amountin the anti clockwise direction.0,552523(5$7,1*326,7,21)0,55256+,33,1*6725$*(326,7,21)Focusing the LensProjector(c) Locking Fastener Ring(b) Main Lens Barrel Tube(a) Front Rotary Lens Ringå çLOCKINGSCREWSLOCKINGSCREWS