Contents - federal communication commission interference statement
- Table Of Contents
- Introduction to the Installation Guide
- About the CSE-800
- CSE-800 Specifications
- About the Base Unit
- usb ports
- About the Button
- usb connector
- Mobile Device Support
- Getting started
- CSE-800 Installation
- how to install
- Ceiling mounting
- Rack mounting
- Recommendations about antenna placement and orientation
- Audio connection
- LAN connection
- Preparing the buttons
- ClickShare Extension Pack
- Accessing the Configurator
- ClickShare Configuration Wizard
- On-Screen Language and Text Size
- Meeting room information
- Personalisation, wallpaper
- Personalisation, Personalized wallpaper
- Manage configuration files
- Display setup, output
- Audio settings
- Display setup, Inputs
- LAN Settings
- Network integration, activation
- security modes
- Network integration, EAP-TLS security mode
- Network integration, EAP-TTLS security mode
- Network integration, PEAP security mode
- Network integration, WPA2-PSK security mode
- Services, mobile devices
- Service, ClickShare API, remote control via API
- Security, compatibility
- Security, security level
- Security, passwords
- Status information Base Unit
- Date & Time setup, manually
- Date & Time setup, time server
- Energy savers
- Buttons
- Firmware Update
- Factory defaults
- how to restore factory defaults
- Software updates
- Troubleshooting
- Environmental information
- Importers contact information
- Index
|
6. CSE-800 ConfiguratorBelow the channel selection pane, an indication is given of the available bandwidth of the current channel. To see if sufficientbandwidth is available in a different channel, select the channel in the dropdown and save the changes. The page will reloadwith the new settings and an indication of the channel fit will be given after approximately 1 minute. There is no need to reloadthe page to see the result.The channels available in the list vary according to the regional version of your Base Unit. Re-pairing the Buttons is not requiredwhen changing the frequency band or wireless connection channel.Make sure your PC’s wireless interface supports the 5 GHz band before selecting it on the Base Unit.SSID1. Enter a public name (SSID) for the wireless network.The default SSID is ClickShare-.2. If you want to broadcast this SSID, check the checkbox before Enable SSID broadcast.WiFi passphrase1. Enter a new WiFi passphrase.2. Confirm that new WiFi passphrase.Signal strength1. Select the Signal Strength. Click on the slider and reduce the broadcasted power (signal strength) until the desired strength isobtained.Note: Too low power and interference by others might lead to connection issues. If so, increase again the signal strength untilthe issues are solved.By default the strength is set to 100%.Button connect1. Click on the drop down box next to Button connects to and select the WiFi frequency to which the buttons are connected.Note: Changing that setting will require a repairing of the buttons.WebUI access via Wi-Fi1. To allow access to the configurator via Wi-Fi, check the check box in front of WebUI available via Wi-Fi.Checked: Configurator accessible via Wi-Fi.Not checked: access to the configurator via Wi-Fi is blocked.6.12 LAN SettingsAbout LAN network settingsA network connection can be configured through DHCP or by manually entering a fixed IP address.The LAN interface is split up in a primary interface and a secondary interface. During normal operation both LAN inputs have thesame functionality. During standby, the primary interface acts as an network standby and the secondary interface is than switchedoff.A practical example as use case:Integrate ClickShare within a network to manage and integrate into a network to share. For integration, one should preferably usethe primary network connector as the Buttons can only wake up the Base Unit from network standby using the primary connector.C AUTION : Both LAN connections must be connected to two different networks.R5900049 CLICKSHARE CSE-800 19/03/2018 45
|
