Barco NGS-D200 User Manual

Also see for NGS-D200: Quick start guide

Contents

Barco NGS-D200 User Manual Manual pdf 49 page image

Chapter 10: Decoding SettingsChapter 10: Decoding SettingsThe following topics are covered in this chapter:10.1 Decoding Settings41This menu is used to configure various decoder settings.10.1 Decoding Settings10.1.1 Display ParametersDecoder Display Parameters is used to switch the decoder video mode from Local to Remote modes and is also used toset the positioning of the video on the decoder and encoder sides.Field Default Value Valid EntriesVideo Source Remote Local, RemoteOverride Monitor Monitor, NoneOverride Color Blue Blue, Yellow, Magenta, Cyan, Black, White, Gray, Red, GreenHoriz/Vert Position Location, Location Location, OffsetHoriz Location Left Left, Center, RightVert Location Top Top, Middle, BottomHoriz/Vert Offset 0, 0 0-horizontal (from left) or vertical (from top) pixelsTable 10-1: Default/Valid Decoder Display Parametersl Video Source: Allows you to switch output video from Local, Remote modesl Override: This menu allows you to define the scheme to render video on the decoder. You can choose to rendervideo in one of several ways:o Monitor: Video is rendered to fit the best supported resolution of the monitoro None: Video is rendered to match the resolution of the encoded video (at the encoder end)l Override Color: If the scheme you select to render your video creates a negative space boarder around your video,you can select what color the negative space will bel Horz/Vert Position: Controls what scheme the system uses to offset the videoNOTE: When set to 'Location,' Horiz/Vert Location will be used to offset the video. When set to "Offset,"Horiz/Vert Offset will be used to specify the offset (pixels).l Horiz Location: When Horiz Position is set to 'Location,' specifies the horizontal location of your videol Horiz Offset: When Horiz Position is set to 'Offset,' specifies the horizontal location of your video in relation to theleft edge of the displayl Vert Location: When Vert Position is set to 'Location,' specifies the vertical location of your video41 NGS-D200 User Guide