Appendix VII: Safety and Compliance StatementsAppendix VII: Safety and ComplianceStatementsVII.1 Compliance StatementsFederal Communications Commission (FCC) StatementThis equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of theFCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment isoperated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if notinstalled and used in accordance with the instruction manual, may cause harmful interference to radio communications.Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will berequired to correct the interference at his own expense.Barco is not responsible for any radio or television interference caused by unauthorized changes or modifications to thisequipment. Unauthorized changes or modifications could void the user’s authority to operate the equipment.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:1. this device may not cause harmful interference, and2. this device must accept any interference received, including interference that may cause undesired operation.Industry Canada Class A Emission Compliance StatementThis Class A digital apparatus complies with Canadian ICES-003.Avis de conformité à la réglementation d’Industrie Canada Cet appareil numérique de la classe A est conforme à la normeNMB-003 du Canada.Australia and New Zealand Class A StatementAttention: This is a Class A product. In a domestic environment this product may cause radio interference in which casethe user may be required to take adequate measures.European Union EMC Directive Conformance StatementThis product is in conformity with the protection requirements of EU Council Directive 2004/108/EC on the approximationof the laws of the Member States relating to electromagnetic compatibility.Barco cannot accept responsibility for any failure to satisfy the protection requirements resulting from a nonrecommendedmodification of the product.This product has been tested and found to comply with the limits for Class A Information Technology Equipment accordingto CISPR 22/European Standard EN 55022. The limits for Class A equipment were derived for commercial and industrialenvironments to provide reasonable protection against interference with licensed communication equipment.Attention: This is a Class A product. In a domestic environment this product may cause radio interference in which casethe user may be required to take adequate measures73 NGS-D200 User Guide