Barco R9002130 Owner's Manual
Also see for R9002130: Owner's manualOwner's manual
                                                  | |
Contents
| 
Controlling4-35975039 BARCOVISION 508 100698To continue using the RCU, it is necessary to enter an address withthe digit buttons (address between 0 and 9). For example : if theAddress key displays projector address 003, the press "3" digitbutton on the RCU to set the RCU's address to match the projector'saddress. Do not press digit 003. This will address the remote to '0'and control all projectors in the room.How to program an address into the RCU?Press the ADDRESS key (recessed key on the RCU) with a penciland enter the address with the digit buttons. That address can beany digit between 0 and 9.Input selectionSource No Projector input Press button1 Comp. Video 12 S-Video 23 RGsB 43 RGBS 53 YsUV 63 YUVS 7Two possible ways of selecting an input :a) With the digit buttons on the RCU, it is possible to select one of theseven input sources, Video, S-Video, TV-Video, RGsB or RGBS,YsUV and YUV.b) With the local keypad :press first the ADJUST key to display the General access menu.Use the control disc to highlight the desired source number. Push thecontrol disc up or down to move the cursor up and down, push thecontrol disc to the left or to the right to move the cursor to the left andto the right.Press ENTER to confirm your selection.When a valid and available source is selected, there will be informa-tion displayed on the screen about that source. This informationincludes :- Source number- Horizontal frequency- Vertical frequencyWhen the entry is a non valid source number, a warning appears onthe screen : 'input not available'.When a valid source number is selected, the projector will display thissource or it will wait on the selected source number until the sourcebecomes available. A message 'source not available' will bedisplayed for a short time.GENERAL ACCESSSelect with ,orthen |
Related manuals for Barco R9002130
manualsdatabase
Your AI-powered manual search engine