Downloaded from Projector.comGetting Started3-75976197 BARCOCINE 7 10012001GENERAL ACCESSSelect with ,orthen . to returnSHARPNESSTINTCOLORBRIGHTNESSCONTRAST5 63 41 2Enter ADJUSTGENERAL ACCESSSelect with ,orthen . to returnSHARPNESSTINTCOLORBRIGHTNESSCONTRAST5 63 41 2Enter ADJUSTSource 2Fh= 15.6 kHzFv= 50 HzADJUSTSTANDBY ENTEREXITInput Selection via the Local Keypad.Handle as follow :1 Press the ADJUST key to display the General access menu (menu 1).2 Highlight the desired source number by pushing the control disc up, down, to the left or the right. Push the control disc up or downto move the cursor up and down, push the control disc to the left or to the right to move the cursor to the left and to the right.3 Press ENTER to confirm your selection.When the source is selectedWhen a valid and available source is selected, there will be information displayed on the screen about that source. This informationincludes :- Source number- Horizontal frequency- Vertical frequencyWhen the entry is a non valid source number, a warning appears on the screen : 'input not available'.exsxq 2When a valid source number is selected, the projector will display this source or it will wait on the selected source number until thesource becomes available. A message 'source not available' will be displayed for a short time.exsxq 2ADJUSTSTANDBY ENTEREXITPicture controlsThe picture controls can be adjusted with :With the RCUThe control keys are located on the left side of the key panel of the RCU and indicated with the name of the control and an icon.When an image control is pressed, a text box with bar scale and the function name of the control, e.g. 'brightness...' appears on thescreen (only if text is ON). The length of the bar scale indicates the current memorized setting for this source. The bar scale changesas the + or - side of the button of the control are pressed.With the local keypadAll controls are hidden in the General access menu.1 Press ADJUST to display the General access menu.2 Use the cursor keys to highlight the desired analog control and3 Press ENTER to select.