Barco RETRO GRAPHICS 2100LC R9001319 Owner's Manual

Contents

Barco RETRO GRAPHICS 2100LC R9001319 Owner's Manual Manual pdf 13 page image

3-2Power Connections5975958A RETRO GRAPHICS 2100LC 210898FRONT CONTROL PANEL+++++097 8654321+BALANCE++VOLUME+BASS+CONTRASTTREBLEBRIGHTNESSCOLORTINTSHARPNESSADJFREEZEMUTEPHASEEXITPAUSE TEXTSTBYENTERBBBBBBBBBBADDRREMOTE CONTROL PANELHELPStand-By buttonPower SwitchProjector Status LEDProjector status LEDNo light up : projector switched offGreen color : projector in Operational modeRed color : projector is in Stand-by mode.To start image projection, press the 'Stand by' button on the front localcontrol keypad or on the remote control. The projector mode statusLED lamp will be green.When switching 'on' with the power switch, the projector starts inthe stand by mode. The projector mode status LED lamp is red.Switching to stand-byWhen the projector is running and you want to go to stand-by, pressthe stand-by key.Caution : Before powering down the projector, switch the projectorto stand-by and let the projector lamp cool down until the fans stopblowing (or for at least 15 minutes).Switching offTo switch off:- press firstly the STAND-BY key and allow projector to cool downuntil the fans stop blowing (or at least 15 min).- then switch off the projector with the power switch on the front localcontrol panel.Switching onUse the power switch to switch on the projector, using the switchon the front local control panel.When '0' is depressed, the projector is switched off.When '1' is depressed, the projector is switched on.The projector is switched ON and OFF using the power (mains)switch ON/OFF on the front local control panel keyboardTo gain access to the keyboard, refer to 'Front local Control paneldescription and function' in chapter 1 'Location and function ofcontrol'.1 Pressed : ON0 Pressed : OFF30 hours before end of lamp lifetime, the following message will scrollover the screen for 1 minute. This message will be repeated every30 minutes. Press EXIT to remove the message before the minuteis over.When the end of lamp lifetime is reached, the following message,with the exact run time is displayed on the screen.Lamp run time is 1000 hours. Operating the lamp longer than 1000hours may damage the projector. Please replace the lamp.When OK (ENTER) is pressed to go on, the warning will be repeatedevery 30 minutes.The total lifetime of the lamp for a safe operation is depending on thetype of lamp and on the operating mode. The different values areshown in Table 1.Do not use it longer. Always replace with a same type of lamp. Calla BARCO authorized service technician for lamp replacement.Warning : Using a lamp longer than Lamp Lifetimeis dangerous, the lamp could explode.Note: Switching the projector OFF and ON again,adds 45 minutes to the lamp run time.Lamp lifetimeArticleNumbreDimming / LampDrive ModeLampLifetimeR9829510 Dimming 1000R9829600 EconomicNormal35002000R9829740 Dimming 4000Remaining lamprun time: 20 hours