R5906151 /02 XDL 45Status overviewOnce the projector is started, press the Menu Activation button to get an overview of parameters such as :• Device serial number and article number• Current firmware version and model name• Current illumination (in percentage)• Projector runtime in hours• Uptime in hours• Chosen source• Current resolution and refresh rate• Chosen communication method and IP address (if connected)• Active functionsStarting image projection1. Make sure the available sources are connected to the appropriate input ports.Tip: If properly connected, the “SYNC” LED will light up ORANGE.2. Press the Input Selection button on the keypad or on the remote control until:• the LED of the selected source (the “SEL” LED) light up GREEN, and• the image of the selected source is projected.1 2Image 4-34.2 Switching to standbyAbout the switch off processTo switch off the projector in a safe manner to protect the internal electronics (avoid moisture due to warmingup) the temperature inside the sealed compartments has to be brought back to ambient in a controlledmanner. This process is called deconditioning.How to switch to standby1. Press and hold the Power on/off button for 3 seconds on the local keypad, or press the Power Off button onthe remote control.Caution: Do not switch off the power from the projector until the laser status light is off. Also make surenot to power off the chiller(s). The chiller(s) should remain on as long as the projector is powered on.The projector goes to standby mode. The deconditioning cycle will start and the lasers will be turned off.During this period the Power on/off button will blink. Once the deconditioning cycle has ended, the projectorwill be in preconditioned state. If left alone, the projector will eventually go into standby mode. In both states,the power on/off button will be lit WHITE.Keep in mind that it can take up to 10 minutes to start the lasers again after they were switched off.If there are only 30 to 45 minutes between the shows it’s advisable to keep the lasers on withshutter closed. When the shutter is closed the lasers are automatically dimmed.Getting Started
