4. Setup5. Press ENTERA dialog box appears on the screen.Entering the new common address ?1. Enter the new projector address with the digit keys on the RCU, the local keypad or the cursor keys.This address must be between 0 or 1.4.6 OrientationProjector orientationsDepending on how the projector is oriented, the projector’s internal settings have to be adapted.How to change the orientation ?1. Press MENU to activate the Toolbar2. Press → to select the Installation item3. Press ↓ to Pull down the Installation menu4. Use ↑ or ↓ to select Orientation5. Press → to pull down the menu6. Use ↓ or ↑ to select the desired orientation (image 4-8)7. Press ENTERThe projection is adapted and a black bullet shows the active configuration.Image 4-84.7 Adjusting the lensWhat must be done ?Depending on the projection distance and the lens used, the image may not be at the desired size, position and/or may be out offocus.The projector will always allow you to shift your image vertically as well as horizontally (when available) to position it on the screen.In addition, motorized lenses will also allow you to Zoom and focus the image.All these lens parameters can be adjusted using the RCU, the local keypad or in the Installation menu of the projector’s OSD.• Zoom (only for motorized lenses)• Focus (only for motorized lenses)• Vertical ShiftR5976874 ID PRO R600/R600+ 21/09/2006 21
