6. AdvancedImage 6-4The Barco logo on the menu indicates the presence of a signal, the digit indicates the shortcut key on theRCU.The 3 first sources (Data on BNC’s, Component Video & RG(s)B) refer to the 5-cable input, the position of theindication “1” will always show which BNC configuration is selected.When to select “Data on BNC’s”Select Data on BNC’s when a data signal is connected to the BNC’sWhen to select “Component video” ?Select Component video when a video signal of the type (R-Y/Y/B-Y) is connected on the BNC’s.When to select RG s B Video ?Select RG sB Video when an RGB video signal (15 KhZ) with Sync on green or sync on H is presented on the BNC’s.This signal is routed to the video circuit and is projected in a Video Window.6.2.2 Composite VideoHow to select one of the 7 composite video inputs ?1. Press MENU to activate the Tool bar2. Press ↓ to Pull down the Source Selection menu3. Use ↑ or ↓ to select Composite video4. Press → to Pull down the submenu5. Use ↑ or ↓ to select one of the different video inputs (image 6-5)Note: Video2 is an optional Video input and is only displayed in case the optional Video/Audio layer is installed.If the extended mode is disabled, the submenu contains only 1 selection (2 selections if the Audio & Video option isinstalled).6. Press ENTER to confirm your choiceA white bullet indicates the selected composite video source which now appears on the screen.R5976874 ID PRO R600/R600+ 21/09/2006 33
