Bard WG Series Installation Instructions Manual

Also see for WG Series: Installation instructions Installation instructions Installation instructions Installation instructions Installation instructions

Bard WG Series Installation Instructions Manual Manual pdf 16 page image

Manual 2100-587JPage 16 of 599. CLEARANCESMinimum clearances, as specified in Table 2, mustbe maintained from adjacent structures to provideadequate fire protection, adequate combustion air androom for service personnel.While minimum clearances are acceptable for safetyreasons, they may not allow adequate air circulationaround the unit for proper operation in the coolingmode. Whenever possible, it is desirable to allowadditional clearance, especially around the condenserinlet and discharge openings. DO NOT install the unitin a location that will permit discharged air from thecondenser to recirculate to the condenser inlet.TABLE 2Minimum Installation ClearancesOutlet Duct(from combustible materials) 1" first 3'Vent Terminal(from combustible materials) * 17"Condenser Inlet 20"Top See Figure 3Burner Service 20"Combustible Base (Wood or Class A,B or C roof covering material) 0"* See Figure 3FIGURE 7Location of Vent Terminal in ShippingWARNINGClearances from combustible materialsmust be maintained as specified. Failure tomaintain clearances could cause fire resultingin property damage, injury, or death.