Baroness LM283 Owner's Operating Manual

Also see for LM283: Owner's operating manual

Contents

Baroness LM283 Owner's Operating Manual Manual pdf 51 page image

Thermo-start LampThe thermo-start lamp is the middle pilot lamplocated in the lower right of the operationpanel.When the ignition key is set to the "GLOW"position, it illuminates as the glow pluggenerates heat.Illumination of the thermo-start lamp iscontrolled by the glow lamp timer, and the lampis turned off after a specified amount of timepasses.Duration of illumination indicates anapproximate period of time required for warm-up, and has been fixed to five seconds.1ࠫ࡯ࡖ࠴ ࠛ࠻࡯࠲ࠬࡕ࡯ࠨ ᴤ࿶ࡦࠫࡦq44uug-001Thermo-start Lamp_0011 Thermo-start lampOil Pressure LampThe oil pressure lamp is the right pilot lamplocated in the lower right of the operationpanel.It turns on when the ignition key is set to "ON"before the engine starts. It turns off when theengine starts and engine oil pressure isgenerated properly.If this lamp illuminates while you are operatingthe machine, stop the engine immediately, andinspect and perform necessary maintenance ofthe machine.1ࠫ࡯ࡖ࠴ ࠛ࠻࡯࠲ࠬࡕ࡯ࠨ ᴤ࿶ࡦࠫࡦ1ldikn-001Oil Pressure Lamp_0011 Oil pressure lampAngle MeterThe angle meter is located in the upper center ofthe operation panel.This instrument indicates the angle of themachine position.Travel of MachineMoving the MachineBefore starting the engine, check thefollowing points.An operator is sitting on the seat.The parking brake lever is pulled.The reel rotation lever is shifted to the"Stop" position.Start the engine.Raise all mower units, and set the anti-fallingstop valves to the "Stop" position.Depress the brake pedal, and while pressingthe push button, return the parking brakelever to its resting position.Slowly depress the traveling pedal.The machine will start to move.Towing the MachineIf the machine does not travel due to enginetrouble, etc., you can move it in the followingways:Pushing by handTowing (See the following instruction.)CautionTow the machine at a low speed while payingclose attention.CautionBefore restarting the engine, be sure to closethe unload valve.Stop the engine.Pull the parking brake lever and chock thewheels.Lift the seat.1.･･･2.3.4.5.6.･･1.2.3.Handling InstructionsLM283Handling InstructionsPage 8-23Travel of Machine