5Bartels Mikrotechnik GmbH, Otto-Hahn-Str. 15, 44227 Dortmund, Germanywww.micro-components.com, microComponents@bartels-mikrotechnik.deTel: +49-231-9742-500, Fax: +49-231-9742-5012. Proper use2.1 Intended purposeThe micropump is intended for pumping liquids or gases with varying flow rates controlled by theelectronics. The mp-x, the mp6-a, mp6-OEM and mp6-EVA controllers are intended for operating one mp6or one mp6-pp. Any other use of the micropump or controller unit is deemed improper.Do not make any modifications or extensions to the pump or controller without the prior written consent ofthe manufacturer. Such modifications may impair the safety of the unit and are prohibited. BartelsMikrotechnik GmbH rejects any responsibility for damage to the unit caused by unauthorized modificationsto the pump and risk and liability are automatically transferred to the operator.2.2 MisuseThe use of liquids, which may alone or in combination create explosive or otherwise health-endangeringconditions (including vapors) is not permitted.2.3 Staff selection and qualificationAll work in connection with the installation, assembly, commissioning/decommissioning, disassembly,operation, servicing, cleaning and repairing of the pump and the controller must be carried out by qualified,suitably trained and instructed personnel.Work on electrical components and assemblies must be carried out by personnel with the necessaryqualifications and skills.2.4 About this operating manualWarnings and important notes are clearly identified as such in the text. The relevant text sections feature aspecific sign. However, this icon cannot replace the safety instructions. Therefore, carefully read all safetyinstructions in this manual. Warnings and important notes in this text are highlighted as shown below,according to the severity of the damage that might result from non-compliance.DANGERDANGER INDICATES A HAZARD WITH A HIGH LEVEL OF RISK WHICH, IF NOT AVOIDED, WILLRESULT IN DEATH OR SERIOUS INJURY.