Batco 1565 SA Assembly Manual
Also see for 15100 SA: Operator's manual
                                                                                                            | |
Contents
| 
34 P1512114 R4Figure 19. Tapering the Trailing Edge of the BeltNOTCHEDBELT TRAVELDIRECTIONTRAILINGSIDE OFBELTTighten the Conveyor BeltUse the hopper roller bolts to set the belt tension.1. Tighten the hopper roller bolts until the conveyor belt deflects 1–2” when pushed down with a 5 lb force.2. Measure to be sure both sides are set at the same position.The belt will require final tension and alignment after the conveyor is fully assembled.4.8. Install the Collapsible Hopper ClothInstalling the collapsible hopper cloth follows the same basic procedure for all series of Swing Away conveyors.Install the Hopper Cloth Frame1. Slide the two upper side frames (1, 6) into the hopper cloth (2).2. Slide the upper front frame (8) into the hopper cloth.3. Loosely attach the upper side frames to the upper front frame using 5/16" x 1" hex bolts (9) and 5/16" nuts(10).4. Slide the four lower side frames (4, 5) into the hopper cloth.5. Slide the lower front frame (7) into the hopper cloth.6. Slide the two lower back frames (3) into the hopper cloth.4. ASSEMBLY PORTABLE GRAIN BELT CONVEYOR – SWING AWAY |
Related manuals for Batco 15100 SA
manualsdatabase
Your AI-powered manual search engine