ImVT 120 II Mini VerticusPage 56 1st Edition, Rev. 0 Chg. 105.1.3 Manual Condensate DrainageThe condensate must be drained from the oil and water separator before changing any cartridge, beforebeginning each filling procedure and in the absence of an Automatic Condensate Drain System, every fif-teen minutes during the filling procedure. This is done by slowly opening the condensate drain valves.They are opened approximately 1/3 of a turn to the left and held open until the condensate is completelydrained. The condensate drain valves close by spring pressure but if necessary may be tightened by handto ensure they are completely air tight.5.1.4 Model, Serial Number and Part Number Identification5.1.4.1 Compressor DataplateThe model number, date of manufacture and serial number can be found on the compressor unit identifi-cation plate in the main electrical enclosure and frame.5.1.4.2 Purification System DataplateRefer to the compressor unit purification system dataplate (See Figure 5-2) on the compressor front todetermine your air processing system model and specifications.5.1.4.3 Cartridge Installation DataplateThe function performed by each chamber in the air processing system is determined by the type of car-tridge installed in that chamber. Refer to the cartridge installation dataplate on the chamber to determinethe purpose and part number of the cartridge installed in that chamber. (See Figure 5-2).Figure 5-2 Purification System Dataplates (typical)Purification System Cartridge InstallationCARTRIDGE FORCARTRIDGE NO.LBL-CARTRIDGE TO BEINSTALLED1328 Azalea Garden Road - Norfolk Virginia 23502-1944Phone: (757) 855-6006 Fax: (757) 855-8224MODEL NO.MAX. PRESSUREAIR PROCESSEDO-RINGBACK-UP RINGpsigcu. ft.LBL-PURIFICATIONSYSTEM
