Beamz BAC406 Instruction Manual

4DISPLAY The control board offer several features: you can simple set the starting address,run the pre-programmed program or make a reset. The main menu is accessedby pressing the Mode-button, browse through the submenu by pressing Up orDown.Press the Enter-button in order to select the desired menu.You can change the selection by pressing Up or Down. Confirm every selectionby pressing the Enter-button.You can leave every mode by pressing the Mode-button. The functions providedare described later in this manual.DMX-512 CONNECTIONIf you are using a standard DMX controller, you can connect the DMX-output of the controller directly to the DMX-input of thefirst unit in a DMX-chain. Always connect the output of one unit with the input of the next unit until all units are connected.If you use a controller with 5 pin DMX connection you will need to use a 5-pin to 3-pin adapter.At the last fixture, the DMX cable has to be terminated. Solder a 120 Ohm resistor between signal (-) and signal (+)into a 3-pin XLR connector and plug this into the DMX output of the last fixture in the chain.REMOTE CONTROLLERBLACK OUT ModePress off existing modes. Press return the last modes.AUTO ModeAutomatic mode will enable you to run the automatic programs on the product.To turn on Automatic mode:1. Press on the remote controller.2. Press <+> or <–> to choose between the different auto programs.SOUND ModeSound-Active mode will enable the product to respond to the music.To turn on Sound-Active mode:1. Press on the remote controller.2. Press <+> or <–> to choose between the different sound programs.STROBE ModeTo adjust the strobe speed of the automatic program and the sound active program.1. Press on the remote controller.2. Press <+> or <–> to either increase or decrease the speed of the program.3. Press again to turn off the strobe.SPEED ModeTo adjust the speed of the automatic program and the sound active program.1. Press on the remote controller.2. Press <+> or <–> to either increase or decrease the speed of the program.SENSITIVITY ModeTo adjust sound sensitivity for in Sound-Active mode1. Press on the remote controller.2. Press <+> or <–> to either increase or decrease sound sensitivity.DMX / % ModeTo enable DMX or disallow DMX on the product.Press on the remote controller, the product work on the DMX controlling modes.