Beamz Fuze 610Z WASH User Manual

Contents

The buildup of dust, dirt and other airborne particles will reduce the fixture’s light output. It will also prevent the fixtu re from cooling correctly, and thiswill reduce the fixture’s lifetime. The rate of dirt buildup will vary depending on environmental factors such as airborne dust, use of smoke machines,airflow from ventilation systems, etc. The fixture’s cooling fans will accelerate buildup, and any smoke particles that are p resent in the atmosphere willincrease the tendency for dirt to clog.To get the best performance and lifetime from the fixture, inspect it regularly and clean it as soon as you see signs of dirt buildup.Assess the operating environment each time you begin to use the fixture. In dusty or smoky conditions, inspect the fixture after a few hours and checkit frequently the fixture may attract dirt faster than you expect. Draw up a cleaning schedule that will make sure that dirt is removed before it can buildup.Use the following guidelines:• Disconnect the fixture from power and allow it to cool completely before cleaning.• Do not use solvents, abrasives or any other aggressive product to clean the fixture.• Vacuum or use low-pressure compressed air to remove dust and loose particles from surfaces and air vents. Prevent the blades of cooling fansfrom turning before you aim a vacuum or air jet at the fan, or you may spin the fan too fast and damage it.• Clean glass components by wiping gently with a soft, clean, lint-free cloth moistened with a weak detergent solution. Put the solution on thecloth and not on the surface to be cleaned. Avoid rubbing glass surfaces. If particles are stuck to the glass, try to lift them off by dabbing themrepeatedly with a cotton swab or moistened lint-free cloth.• Dry the fixture with a soft, clean, lint-free cloth or low-pressure compressed air before reapplying power.If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.Procedure:Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.Step 2: Remove the old fuse from the fuse holder.Step 3: Install the new fuse in the fuse holder.Step 4: Replace the fuse holder in the housing.